3d_printing
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| 3d_printing [2020/01/03 17:06] – [GCode editor] ashley | 3d_printing [2020/01/06 06:58] (current) – [Rasberry Pi Controllers] ashley | ||
|---|---|---|---|
| Line 28: | Line 28: | ||
| If you are looking down at the printer from above, turning the wheel clockwise will move the corner of the bed downward, away from the nozzle. Turning the wheel counter-clockwise will move the corner of the bed upward, toward the nozzle. | If you are looking down at the printer from above, turning the wheel clockwise will move the corner of the bed downward, away from the nozzle. Turning the wheel counter-clockwise will move the corner of the bed upward, toward the nozzle. | ||
| - | ===== Rasberry Pi Controllers===== | + | ====== Rasberry Pi Controllers====== |
| + | [[https:// | ||
| ===== SLA printers; ===== | ===== SLA printers; ===== | ||
3d_printing.1578071193.txt.gz · Last modified: (external edit)