The Slades Wiki

Edit the page and hit Save. See syntax for Wiki syntax. Please edit the page only if you can improve it. If you want to test some things, learn to make your first steps on the playground.

====== Enable card ======
edit boot file

sudo nano /boot/config.txt

add this at end

dtparam=spi=on
  dtoverlay=mcp2515-can1,oscillator=16000000,interrupt=25
  dtoverlay=mcp2515-can0,oscillator=16000000,interrupt=23
  dtoverlay=spi-bcm2835-overlay
  
After reboot, check its enabled and loading

dmesg | grep -i '\(can\|spi\)'

from https://www.waveshare.com/wiki/2-CH_CAN_HAT
----------------------------

====== Install VE CAN Setup ======

https://github.com/kwindrem/VeCanSetup:

install package
  wget -qO - https://github.com/kwindrem/SetupHelper/archive/latest.tar.gz | tar -xzf - -C /data
  mv -f /data/SetupHelper-latest /data/SetupHelper
  /data/SetupHelper/setup
 
Then, in venusOS, go into package manager and install vecan setup

/data VeCanSetup/setup

* select i to install
  * select enter to NOT add USB
  * confirm to not add any changes
  * interface will be detected along with an offer of reboot

====== Enable in VRM ======

Go to system, Settings, Services and enable CAN 0

=====Install Battery Emulator=====
https://github.com/drurew/Battery-Aggregator

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International